Si tu comprends le pas francais mais c'est ce que je te disais + haut il y E000
Main Cause
The main thermistor (TH1) has poor contact or an open circuit.
The thermal switch (TP1) has an open circuit.
The fixing heater has an open circuit.
The SSR is faulty.
The DC controller PCB is faulty.

Mode of Detection
0000 After the main power switch is turned on, the temperature detected by the main thermistor does not reach 70°C.

Caution The error must be reset in service mode (COPIER>FUNCTION>CLEAR>ERR).

4.1 Troubleshooting by Malfunction
4.1.1 E000
Thermistor (TH1, TH2)
1) Clear E000, and turn off and then on the main power switch.

Make the following selections in service mode:
COPIER>DISPLAY>ANALOG. Does <FIX-U> show an increase in
temperature?
YES: The thermistor is faulty. Check the following:
• thermistor for mounting condition
• thermistor for soiled surface
• connection

a des jours ou rien ne va mais le principal c'est une bonne sante