Comment utiliser HyperCam2

Bonjour,



Je voudrais savoir comment utiliser HyperCam2 car quand je l'ouvre ia ecris:HyperCam ver 2.14.02 is already installed on is the machine.Would you like to run this Setup Again to repar hypercam files puis je fais Oui

ensuite Software License Agreement for HyperCam.

This is a legal agreement between you and Hyperionics Technologies, Inc.
covering your use of HyperCam (the "Software"). Be sure to read the
following agreement before using the Software. BY USING THE SOFTWARE
(REGARDLESS IF YOU HAVE REGISTERED THE SOFTWARE OR NOT),
YOU ARE AGREEING TO BE BOUND BY THE TERMS OF THIS AGREEMENT.
IF YOU DO NOT AGREE TO THE TERMS OF THIS AGREEMENT, DO NOT
USE THE SOFTWARE AND DESTROY ALL COPIES IN YOUR POSSESSION.

The Software is owned by Hyperionics Technology, LLC and is protected by
United States copyright laws and international treaty provisions.
Therefore, you must treat the Software like any other copyrighted material
(e. g., a book or musical recording). Paying a single user license fee
allows you the right to use one copy of the Software on a single computer.
You may not network the Software or otherwise use it or make it available
for use on more than one computer at the same time. Corporate customers
with multi-user network licenses should undertake a reasonable effort to
make sure that the total number of concurrent users within their
organization does not exceed their license user limit. You may not rent
or lease the Software, nor may you modify, adapt, translate, reverse
engineer, decompile, or disassemble the Software. If you violate any part
of this agreement, your right to use this Software terminates
automatically and you must then destroy all copies of the Software in your
possession.

The Software and its related documentation are provided "AS IS" and
without warranty of any kind and Hyperionics Technology expressly
disclaims all other warranties, expressed or implied, including, but not
limited to, the implied warranties of merchantability and fitness for a
particular purpose. Under no circumstances shall Hyperionics Technology
be liable for any incidental, special, or consequential damages that
result from the use or inability to use the Software or related
documentation, even if Hyperionics Technology has been advised of the
possibility of such damages. In no event shall Hyperionics Technology'
liability exceed the license fee paid, if any.

This Agreement shall be governed by the laws of the State of Pennsylvania.
If for any reason a court of competent jurisdiction finds any provision of
the Agreement, or portion thereof, to be unenforceable, that provision of
the Agreement shall be enforced to the maximum extent permissible so as to
effect the intent of the parties, and the remainder of this Agreement
shall continue in full force and effect.

The Software and documentation is provided with RESTRICTED RIGHTS. Use,
duplication, or disclosure by the Government is subject to restrictions as
set forth in subdivision (b)( 3)( ii) of the ASPR Rights in Technical Data
and Computer Software clause as 252. 227- 7013. Manufacturer is:
Hyperionics Technology, 3146 Chestnut Drive, Murrysville, PA 15668, USA,
info@hyperionics.com.

Copyright (C) 1995-2007 by Hyperionics Technology, LLC. All rights
reserved. Hyperionics, HyperSnap-DX, HyperCam and FileBox eXtender are
trademarks of Hyperionics Technology, LLC.


Et en dessous ia si j'acepte j'acepte je ais ok!puis yac:\program files\hycam2je fais ok
et ya ecris Hyper Cam instalation finiched ensuite je fais comment?