Disk extern lu comme boot device ??
Résolu/Fermé
FredSt
Messages postés
2
Date d'inscription
mardi 4 avril 2006
Statut
Membre
Dernière intervention
4 avril 2006
-
4 avril 2006 à 10:16
FredSt Messages postés 2 Date d'inscription mardi 4 avril 2006 Statut Membre Dernière intervention 4 avril 2006 - 4 avril 2006 à 17:56
FredSt Messages postés 2 Date d'inscription mardi 4 avril 2006 Statut Membre Dernière intervention 4 avril 2006 - 4 avril 2006 à 17:56
A voir également:
- Disk extern lu comme boot device ??
- Check disk - Guide
- Dual boot - Guide
- Disk boot failure insert system disk and press enter - Guide
- Boot camp - Télécharger - Systèmes d'exploitation
- List disk - Guide
1 réponse
FredSt
Messages postés
2
Date d'inscription
mardi 4 avril 2006
Statut
Membre
Dernière intervention
4 avril 2006
4 avril 2006 à 17:56
4 avril 2006 à 17:56
Mon pb est résolu : réponse de lacie trouvée sur un autre forum :
For Big Disk Triple Extreme or Big Disk USB or Bigger Triple Extreme:
(using TI USB bridge).
Please be sure to plug first the power supply and later the USB.
If you don't the drive may not be sometime recognized by the OS, asking
for a driver (TUSB 6250).
In this case, please unplug both USB and Power cable and then plug the
power cable first and then the USB cable. (Unplug only the USB cable
doesn't reset the board).
Please include all previous messages if you reply. This information will
be required by the email support team to further assist you. Thank you.
Answers to most common questions can be found in the manual on the CD
that came with your product or in our FAQs:
http://www.lacie.com/support/faq/
Regards,
Technical Support
-----------------------------------------------------
en francais cela donne on debranche alimentation et usb du disk externe
puis on rebranche l'alimentation, enfin et en dernier lieu seulement on rebranche l'USB
et ça marche !!!
For Big Disk Triple Extreme or Big Disk USB or Bigger Triple Extreme:
(using TI USB bridge).
Please be sure to plug first the power supply and later the USB.
If you don't the drive may not be sometime recognized by the OS, asking
for a driver (TUSB 6250).
In this case, please unplug both USB and Power cable and then plug the
power cable first and then the USB cable. (Unplug only the USB cable
doesn't reset the board).
Please include all previous messages if you reply. This information will
be required by the email support team to further assist you. Thank you.
Answers to most common questions can be found in the manual on the CD
that came with your product or in our FAQs:
http://www.lacie.com/support/faq/
Regards,
Technical Support
-----------------------------------------------------
en francais cela donne on debranche alimentation et usb du disk externe
puis on rebranche l'alimentation, enfin et en dernier lieu seulement on rebranche l'USB
et ça marche !!!