Bonjour,
J'ai installé Slackware, et je voudrais installer ma connection,je fait un ndiswrapper -l, j'ai driver present et driver present.
Lorsque je fait un iwlist wlan0 scan, je trouve mon point d'acces wifi.

Ensuite je fait un :
iwconfig wlan0 essid maconnection node managed key XXXX...
Je fait un Ping, sa ne fonctionne pas,
je fait un dhclient wlan0, j'obtien des DHCPDISCOVER, puis un No DHCPOFFERS received, puis un No working leases in persistent database - sleeping, une solution ?

Voici le resultat de mon iwconfig :

[code]root@darkstar:/etc# iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

wlan0 IEEE 802.11g ESSID:off/any
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:1 Mb/s Sensitivity=-200 dBm
RTS thr=2346 B Fragment thr=2346 B
Encryption key:0000-2163-E9BD-F0 Security mode:restricted
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0/code

[code]root@darkstar:/# lspci -vv
05:01.0 Ethernet controller: Marvell Technology Group Ltd. 88w8335 [Libertas] 802.11b/g Wireless (rev 03)
Subsystem: Netgear WG311v3 802.11g Wireless PCI Adapter
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 17
Region 0: Memory at febf0000 (32-bit, non-prefetchable) [size=64K]
Region 1: Memory at febe0000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: ndiswrapper/code
[code]root@darkstar:/# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1758 errors:0 dropped:0 overruns:0 frame:0
TX packets:1758 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:148692 (145.2 KiB) TX bytes:148692 (145.2 KiB)

wlan0 Link encap:Ethernet HWaddr 00:1b:2f:d0:c1:c8
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:17 Memory:febe0000-febf0000/code
[code]root@darkstar:/# ping 127.0.0.1
PING 127.0.0.1 (127.0.0.1) 56(84) bytes of data.
64 bytes from 127.0.0.1: icmp_seq=1 ttl=64 time=0.020 ms
64 bytes from 127.0.0.1: icmp_seq=2 ttl=64 time=0.021 ms
64 bytes from 127.0.0.1: icmp_seq=3 ttl=64 time=0.022 ms/code
[code]root@darkstar:/etc# cat resolv.conf
search example.net/code
[code]root@darkstar:/etc# sudo route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
loopback * 255.0.0.0 U 0 0 0 lo/code
[code]root@darkstar:/# sudo dhclient wlan0
Internet Systems Consortium DHCP Client V3.1.2p1
Copyright 2004-2009 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

Listening on LPF/wlan0/00:1b:2f:xxxxxxx
Sending on LPF/wlan0/00:1b:2:xxxxxx
Sending on Socket/fallback
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 8
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 9
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 15
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 7
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 10
DHCPDISCOVER on wlan0 to 255.255.255.255 port 67 interval 12
No DHCPOFFERS received.
No working leases in persistent database - sleeping./code

[code]root@darkstar:/# iwlist wlan0 scanning
wlan0 Scan completed :

Cell 01 - Address: 00:21:63:XX:XX:XX
ESSID:"French_Connection"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.412 GHz (Channel 1)
Quality:42/100 Signal level:-69 dBm Noise level:-96 dBm
Encryption key:on
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s
9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
48 Mb/s; 54 Mb/s
Extra:bcn_int=100
Extra:atim=0/code

C'est pas un probleme de dhcp car j'ai deja 4 ordinateurs connectés par winxp et pas de soucis.

Les infos de ma box :

LAN Interface
IP Address Subnet MAC Address Status
10.0.0.138 255.255.255.0 00:21:63:e9:bd:f0

WAN Interface
PVC VPI/VCI IP Address Subnet Gateway Encapsulation Status
PVC-0 8 /48 90.179.60.182 255.255.255.255 194.228.196.6 Route -PPPoE
PVC-1 8 /35 0.0.0.0 0.0.0.0 0.0.0.0 Bridge -RFC2684

ok, mon inet addr est 10.0.0.22 Bcast : 10.0.0.255 Mask :255.255.255.0
Ce qui je pense est plus correct, mais sa ne fonctionne toujours pas...


J'essaye de ne pas regarder mon cd windows seven pour ne pas succomber a la tentation :D

Configuration: Windows 7
Firefox 3.0.14